1. Introduction CO removal catalyst could be used to remove CO from petro gas, inert gas, oxygen and etc, also could be used in various furnace like oven, chimney place, incinerator to treat not burst CO. Before using, CO removal catalystshould be heated up to 180~200℃ by fresh air, in order to active its performance. The best operating temperature: 250℃-300℃, after light-off, shut down automatically compensate for heating. If the temperature is up to or above 550℃, cool the reactor by heat transfer and recover heat energy. This catalyst could make CO content less than 0.5ppm under space velocity at 1.0~3.0×103 h-1, T02-1 has high crushing strength, with service life at least 2 years. 2. Chemical information Coating ＞10.0 wt% Activity component could be vary with your requirement Expulsion rate ＜1% 3. Physical parameter Item Value Catalyst carrier material alumina + cordierite Specs size depends on operating condition and your demand Appearance Light brown honeycomb Space velocity ≥1×103 h-1 Light-off temperature 100℃-150℃ Operating temperature 250℃-300℃ CO removal ratio ≥98﹪ Service life ≥2 years CO outlet content ＜5ppm Bulk density 0.68±0.05g/mL Crushing strength ≥14 MPa Package moisture-proof Suggested loading ratio 4:01 Height : diameter
联系我时，请说是在找找去看到的，谢谢！