性能及尺寸表 Table2 Dimensions(mm) & Coupling Ratings "型号 Coupling Type" "外径 Dia- meter A" "轮毂 Hub B" "轴孔径 Bore" "常用扭矩 Rated Torque (Kg*m)" "偏心状态 Misalignment" "回转速 Maximum Speed Revolution (r.p.m)" "整组 厚度 L" "单边 厚度 K" "胶圈厚度 H" " 组装 间隙 t+1.0 -0" "毂长 I " "胶圈内径 E" "重量 Weight (kg)" "惯性矩 Moment of Inertia Gd^2 (kg*m^2)" " Max." "小 Min." "中心孔 Stock C" "标准偏差 Parallel" "标准偏角 Angular (deg.)" MH-55 55 38 20 9 7 0.4 0.2 0.3° 6,000 57 27 17 3 15 26 0.6 6.2X^-4 MH-65 65 45 25 12 8 0.7 0.2 0.3° 6,000 63 30 19 3 16 33 0.9 1.5X^-3 MH-80 80 52 30 16 10 1.6 0.2 0.3° 5,500 73 35 23 3 18 41 1.5 3.7X^-3 MH-90 90 62 35 20 12 3.7 0.2 0.3° 5,000 83 40 25 3 21 46 2.2 7.1X^-2 MH-115 115 80 45 25 12 8.0 0.2 0.3° 4,600 113 55 33 3 29 58 5.0 2.7X^-2 MH-130 130 90 50 27 12 12.0 0.2 0.3° 4,400 123 60 37 3 32 65 7.0 4.2X^-2 MH-145 145 100 55 30 12 20.0 0.2 0.3° 4,200 133 65 39 3 35 72 9.2 9.4X^-2 MH-175 175 115 65 35 16 43.0 0.2 0.3° 3,800 163 80 47 3 43 84 16.1 1.9X^-1 MH-200 200 130 80 50 20 65.0 0.2 0.3° 3,600 223 110 53 3 69 92 35.5 3.1X^-1 MH-230 230 150 85 50 20 0.2 0.3° 233 115 56 3 65 110 42.0 使用联轴器，在接近可能速限时请检查动力平衡的情形。 In case the coupling is used near its allowable maximum speed, check the dynamic balance. 若联轴器使用于大扭矩机械上时，孔径需比表2上标示之孔径小上5mm以上。 " In case the coupling is used large torque variation machines, the maximum bore must be smaller about 5mm than in Table 2."
联系我时，请说是在找找去看到的，谢谢！