材质单   COMPONENT 成分  RESULT 结果 
1. Ash content, not more % 灰分，不超过%  0.14 
2. Mass fraction of sulphur, not more % 硫的质量分数，不超过% Low sulphur residual oil 低硫残油 0.5 
3. Temperature of the flash, not less oC火花温度，不低于℃ in the closed crucible闭口坩埚 65   In the open crucible oC开口坩埚，℃ 110 min最低 
4. The temperature of solidification, not higher oC凝固温度，不高于℃  25 
5. Kinematics viscosity运动粘度  118 max最高 
6. Water content含水量   0.5% 
7. Mechanical impurities机械杂质   Lower than低于 0.1% 
8. Acidity酸度  Lower than低于 5 mg KOH/ 100ml 
9. Alkalinity含碱量  Nil 
10. Gross Calorific Value总热值 Kcal/kg / KJ/kg   Min最低9200/41300 
11. Density at 15.0 deg. C Kg/l在15℃时的密度kg/l   0.8900-0.9200 
12. Hydrogen Sulfide Content (H2S) pom硫化氢含量（硫化氢）聚甲醛 
  0.5 max最高 
13. Carbon Residual残碳   Lower than低于 7% 
14. Vanadium钒 (V) ppm  23 
15. Aluminium 铝(Al) ppm   5 
16. Silikon硅 (Si) ppm  12 
17. Nickel 镍(Ni) ppm   49 
18. Asphaltenes 沥青质m/m   3.6% 
19. Destilation @4 mm Hg Extracted to 760 mm Hg蒸馏@4毫米汞柱，提取到760毫米汞柱   Initial Boiling Point deg. C 
初沸点℃ 216    5% recovered deg. C 
恢复5%，℃ 259     10% recovered deg. C 
恢复10%，℃ 310   20% recovered deg. C 
恢复20%，℃ 358   30% recovered deg. C 
恢复30%，℃ 445    40% recovered deg. C 
恢复40%，℃ 502    50% recovered deg. C 
恢复50%，℃ 534   60% recovered deg. C 
恢复60%，℃ 538     75% recovered deg. C 
恢复75%，℃ 545    80% recovered deg. C 
恢复80%，℃   90% recovered deg. C 
恢复90%，℃ 
 20 Final Boiling point deg. C 最终沸点  550 
21 Percent Recovered vol 回收体积   78% 
22   Residue vol 残留提及   22% 
23 COMPONENT 成分   RESULT 
24 Total Nitrogen m/m 总氮   0.19% 
25 20. Sodium (Na) ppm 钠   15
联系我时，请说是在找找去看到的，谢谢！